Conductor board without photoresist coating - This will hold our electrical components - Conrad.Momentary switch - To turn the system on and off - Ebay, Amazon (fancy with LED).Since we will etch the conductor board ourselves we need few more things.

This will shut down the Pi properly and avoid any SD card damages. But I recommend using a soft On/Off circuit. It's possible to use a simple switch to cut power. Įpoxy 2K adhesives (highly recommended) - To keep things in place - Amazon.Screws and nuts M1,6- We need these to hold down the controller PCB - Ebay.Double sided tape - This will keep the battery and the Pi Zero in place.Soldering flux - To create nice & strong solder connections - Amazon.Solder - To connect electrical components and wires - Amazon.Wires - To connect things.Try to get a small cross section (e.g.Mini HDMI to HDMI Adapter - To connect the Pi and the TV - Amazon ( mini HDMI cable is also an option).This basic switch will just cut the power. Slide switch - For a very basic on / off switch.Step up Converter - The battery will give ~3,7V but the Pi Zero needs ~5V - Amazon.Li-Ion charging board 1000mA - Charging board for our battery - Ebay.Blackberry LS1 battery - Our power supply - fits best - Ebay (the height is the critical parameter and should not exceed 5mm).USB Type A to miniUSB Type B adapter cable - Later we will charge from miniUSB- Amazon.5V power supply with MicroUSB cable - To charge the battery - This or this will do it (~2A, 5V).Micro SD Card (4GB+) - This is where our operating system will live - Amazon ( check compatibility).Original SNES Controller - That is how we play - Best bet: Ebay (~15 € is a good deal, be aware of fakes).Raspberry Pi Zero v1.3 - The heart of the build - Provider: PIMORONI, adafruit, PiHut (try to get a kit).

Snes controller original types